Use a 4 1 4 inch hole saw to cut the vent opening.
How to mount a dryer to the wall.
This is using a f p dryer and bracket.
Then go outside and remove any siding trim pieces from around the vent hood.
Disconnect the hood from the stub pipe and toss the hood.
We have a f.
Finishing the hole from the opposite side will help make.
You just loosen the screw on the worm clamps metal circular bands that hold the duct to the vents and pull the duct off.
To get started we pulled our dryer away from the wall and disconnected the duct from the dryer and wall with a flat head screwdriver.
Start by disconnecting the dryer vent from the vent hood stub pipe.
Once the hole saw s pilot bit pops through the exterior go outside to complete the hole using the pilot hole as a guide.
This allows you to push the unit closer to the wall.
That duct caused the dryer to stick out about 6 1 2 inches from the wall.
Next remove the vent hood retaining screws and pull the vent hood and stub pipe out of the wall.