How To Pick A Door Handle Lock With Bobby Pins

When you insert the bent paperclip stick the straightened paperclip beneath it and move it around.

How to pick a door handle lock with bobby pins.

Bend one of the paperclips and fold out the other one as straight as possible. Use a knife or razor blade to remove the rounded rubber tip on the straight side of the bobby pin. Bend one bobby pin at a right angle about two thirds of the way down from the head of the pin the rounded top. Don t press too hard or you risk binding up the lock cylinder and making it more difficult to pick.

You ll use this bobby pin as a lever. A deadbolt would require slightly more control and it goes up from there. All you need is a bobby pin. So ya pick a lock with a bobby pin preformed to look like a nice pick and a proper tension wrench at which point you can just jam it in there and screw off a bunch as long as you hold tension.

To pick a lock with a bobby pin first bend open a bobby pin until it makes a 90 degree angle and remove the rubber piece on the straight end. This bobby pin will serve as the pick that you ll use to unlock the door 1 x research sourcestep 2 remove the rubber tip on the straight end of the bobby pin. Start by pulling the bobby pin apart and roughly straightening it as such. The locks in most houses are fairly basic making this lock picking technique fairly easy.

The two unconnected ends should be perpendicular to the head. This will be your. Can you really open a lock with just bobby pins. Spread the wavy and straight ends of the bobby pin apart so that it bends at the center and looks like an l.

After some wiggling your lock will hopefully open. Most doorknob locks are pretty weak comparatively speaking. Lift the rake upwards into the pins and draw it forward. If you have two paper clips on you the process will be that much easier.

Next try inserting the pick rake at the top of the keyhole and slide it to the back of the lock. Next stick the straight end of the hairpin about one centimeter or about 1 3 of an inch into the keyhole of your lock and apply enough pressure to bend the end of the pin into a hook. Make a slight bend at the tip of the straight end. This will be the end that you ll stick into the lock to pick.

Now take a second bobby pin and bend the closed end to one side so it forms a 90 degree angle. If your door lock has a hole in it and functions similarly to the one in this video check this video out.