How To Pop A Dent From Door Panel

The next thing you need to do is pop the dent out by pulling the plunger back gently.

How to pop a dent from door panel.

If you can identify the exact spot that the panel was hit that would be the best spot to attach the suction cup. Making the surface of the door panel wet and slippery. Use the dryer or gun to heat up the dent and an area a couple of inches around the perimeter of the dent area of the dent. Be sure to use a cup plunger and not a flange plunger as this won t produce the suction you need to get the dent free.

Disconnect battery and any other electronics in the repair area. How to pop a dent on your car s door panel first step. Wet the surface around the dent with water and dish soap to make the surface slippery and wet. How to pull out dents in metal doors step 1.

Making the surface of the door panel wet and slippery. To use you just stick the suction cup puller in the center of the dent. Mix dish soap with water then wet the area around. Mix dish soap with water then wet the area around the dent ensuring that it s slippery.

Evaluate the technique you want to use. Keep the heat source moving to avoid damaging the paint. Just like you would plunge a sink use a plunger on your vehicle. Pull the plunger back gently to pull the dent out.

Take note of how deep and how far the dent extends on the. Now place a plunger in the center of the dent. Pull harder if the first pull doesn t work. Heat the metal door dent with the hair dryer or heat gun holding it a few inches from the metal panel and.

Apply heat with your source of choice. This works well on doors or side panels as suction is created to lift the dent right out. Assess the entire area of the dent in your metal door. You ll want to clean the spot that you re applying the puller to thoroughly before trying to stick it to the car.

To do the job you ll need a hair dryer or heat gun and a can of compressed air like that used to blow dust out computers. How to remove dents from door panels step 1.