How To Program Wayne Dalton Idrive Garage Door Opener

Press and release the program button on your garage door motor and the red indicator light will begin flashing for 30 seconds.

How to program wayne dalton idrive garage door opener.

The idrive will remain in the learn mode for. Make sure the door is closed before you start the programming or reprogramming process. Press the on off reset button on your keypad and wait for the light on the keypad to illuminate. How to reprogram your wayne dalton garage door openers.

The first thing you must do before programming any wayne dalton accessories to your idrive opener system is to pull down on the emergency disconnect cord with the red handle it will be either on the right or left hand side of your garage doors you can t miss it this will release the opener and you will see it flip up in position this is the safest way to program accessories to these openers. The status led and the overhead lamp will flash on and off. Place a step ladder under your wayne dalton garage door opener and climb it locate the program button usually on the side of the opener press the program button three times. Press the red program button on the idrive opener.

Locate the program button on the right side towards the back of the motor head. You have to program in the remotes you buy until 8 positions have been used before you will bump off all previous remote controls programmed to the opener. The opener will beep to indicate that you are programming mode. The wayne dalton remote controls come with instructions for programming the remote control to your garage door opener.

Press the red program button on the idrive opener. Page 36 indicates successful programming of the new frequency signal. It s easiest to program the keyless wayne dalton opener in your hand but if you can t remove it from the wall you can leave it there. It has a red led light above it.

The idrive unit will beep once indicating that it is ready to learn. This can be found on the front cover of the opener.