For example place the right door s upper pivot pin into the upper right bracket.
How to put back sliding closet doors.
The bracket should rest firmly on the floor.
Hook the top rollers back into the top track.
Screw the jamb bracket into the bottom corner of the frame.
This is so the door.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
Afterwards lift the door slightly and then drop the lower pin into the lower bracket slot.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
The runner is what the wheels roll along so the door can slide back and forth.
Because not all doorways are plumb measure the width of the doorway at both.
Sliding doors need to overlap in the center by 2 to 3 inches so keep that in mind as you figure your door measurements.
Then latch the wheels on top of the door onto the back runner of the top track.
If so lift the door and push it in towards the closet.
Hold the door so the top is tilted backward.
Insert the wheels on the top of the first door into the top track.
Attach the track to the header of the frame using the mounting hardware.
If the bottom roller is off its track gently lift the door and push it back into place.