You can cut them to size later on.
How to put up sliding closet doors.
Then hold the spring loaded top pivot down while you swing the top of the door toward the frame and under the door track.
Begin by inserting the bottom pivot into the bracket which can be screwed to the floor to the door jamb or both.
Tip the doors to hook the hangers onto the track.
Attach the hangers to the tops of the doors.
Next measure the closet opening at the top from the left wall to the right wall.
If you have a particularly wide closet you may need to buy more than 2 doors.
Once the door is approximately under the hole in the track release the pivot.
First carefully lean your sliding doors against a nearby wall.
Screw the jamb bracket into the bottom corner of the frame.
It s ok if the tracks you buy are longer than the width of your closet.
Cut your top track to this measurement.
If you do look for.
Sliding doors need to overlap in the center by 2 to 3 inches so keep that in mind as you figure your door measurements.
This is so the door.
The hardware kit specifies the exact locations.
After making sure it s centered connect the upper pivot to the pivoting side of the frame opening.
The bracket should rest firmly on the floor.
To get a straight cut use a miter box and hacksaw.
Look for doors that are slightly shorter than the height of your closet opening.