Replace the screw closest to the doorstop to use this technique remove a screw near the middle of the hinge rather than the top or bottom screw.
How to rehang sliding glass doors.
The top of the door should have wheels that ride against the top shower rail.
Remove the sliding glass door from the track by swinging the bottom toward the back of the shower and then lifting the door until the.
Again put your foot under the door position the roller just to the side of the where the opening on the latch is located.
Stand inside the shower.
Drive in a 3 in.
The edge that is inside of the shower is probably shorter.
Mix the epoxy glue powder with water according to the manufacturer s instructions.
Screw with a drill.
Grasp the near door with both hands.
Using a cordless screw gun remove the screws that attach the hinge to the door jamb.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
It is an extruded aluminum rail.
If you can t find rollers locally type shower door parts into any online search engine to find a supplier.
Using a putty knife force the.
Look at the top track.
Loosen the screws holding the sliding wheels to the top of the door with a screwdriver until you can.
Then move the door.
Lift up any loose splinters with a clean.
How to adjust a hanging glass shower door.
Screw the new rollers into place and rehang the doors is how to install sliding shower doors.
For vertical adjustment lift the door slightly until.
Look at the bottom track.
Adjust the height of the door with your foot until the flange of the pin can slide under the latch then slide it all the way into the latch.
For horizontal adjustment on the top track begin by loosening the screw in the top pivot bracket.
You ll probably have to remove the doors once or twice to adjust the rollers for smooth operation photo 3.
For horizontal adjustment on the bottom track lift the door from the bottom and move the adjusting wheel toward or away.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.