Place the door trim panel to the side disconnecting any harness that may be attached.
How to remove door panel jeep cherokee.
Pull back the rubber door gasket from between the door and the body of the vehicle.
Remove the four speaker screws by turning them counterclockwise with a torx t 20 star bit screwdriver.
Pull the rubber seal then push it through the hole.
Then remove the door handle arms.
Remove the kick panel under the dash and disconnect any wire harnesses coming from the door.
Circle around the edges until the panel comes off.
On some older vehicles the cranks are held on with a.
Instructions 1 start by removing any screws in the door panel.
The oem door speaker is located at the bottom inner corner of the metal door frame.
You have to unscrew the phillips screws then use a putty knife and pry the door panel off of the truck.
After the door panel is free from the metal door frame there will be an electrical plug to remove from the switch.
3 on the 95 cherokee in particular you ll.
Hold panel near frame.
Usually these can be found in the lock release area the door handle.
Continue pulling out the pop rivets all along the bottom and two sides of the panel.
Be careful not to apply too much force or the switch can come apart.
Is very easy to remove the door card what you need to do is to remove three screws and pop up the clips.
Remove torx t 20 screws.
Press the release tab on the grey plastic power plug before sliding it straight out of its socket.
Set the plastic door panel aside in a safe place.
Pull the electrical through.
2 if you have a manual crank window pull hard until it pops off.
Insert the large flathead screwdriver or an automotive panel pry bar tool in to the bottom of the door panel and pry out the white plastic pop rivet friction fasteners.
Insert a large flat wrench or putty knife between the trim panel and door and pop off the plastic retaining plugs.
Jeep cherokee 2014 interior door panel removal.
Just push the tab in and pull the plug to remove it.