How To Remove Retainer Strip On Sliding Door

Then grab the retainer and remove it.

How to remove retainer strip on sliding door.

Hold the outer left lip of the retaining strip on top. Tap the end of the screwdriver until the end of the retainer pops out of the track. Clean the door bottom photo 2 then cut the new rubber seal to length with a razor knife. Fit the straight outer leg into the mounting rail first and then snap in the inner leg which may have a hook.

Remove the wood screws or screws for anchor with the appropriate. Remove the glass and place the screen in the door opening. Next tilt the screw driver at a slight angle tipping the handle towards the door frame. Just type lsailor1 in the youtube search bar.

Ask an assistant to stand on the opposite side of the door from where you are working. Lift up the edge of the carpet to expose the screws that fasten the flat portion of the strip to the subfloor or concrete slab. This video shows you how to take apart sliding glass doors. Start at the top end and slide your finger down the strip while pressing firmly.

This screw is easy to remove but the track cover wraps around the sliding mechanism so you have to remove the track from the. Some retainers will have a slot cut into them for this. If it s especially stubborn cut it and remove it in pieces. To do that place a flat nose screwdriver blade in the groove next to the door frame approximately one inch from the top or bottom of the glass insert.

Be patient it takes a lot of pushing and pulling even with a helper. How to remove the retaining strips holding in the glass panel on a cole sewell storm door. Though you can accomplish this task alone it s. Thread the t shaped edges into the weather seal track then slide the seal across the door.

Keeping your sliding door working perfectly requires an understanding of how it works. If one or both legs are damaged or bent the screw cover strips need to be replaced. A second screw secures the track to the retainer.