How To Remove Wall Mounted Soap Dispenser

The mounting surface must be clean and dry in order for the tape to stick and the silicone to.

How to remove wall mounted soap dispenser.

Pick a replacement sink mounted soap dispenser. 2 drill holes into the marked points using rawl plugs to keep the screws in place if you choose not to use holes left behind from a previous wall mounted soap dispenser. Scott the kemsol guy shows you how to change an empty soap refill in the touch free gojo hand soap dispenser. Just use a cotton cloth to apply the fluid and rug vigorously.

The water dissolves congealed soap. Unscrew the cap from the soap container and remove the dispenser pump assembly. If you are replacing a previously mounted soap dispenser remove the screws and nails with a screwdriver. Set the soap dispenser aside.

Choose the mounting location carefully making sure that there will be enough room above the unit to remove and refill the soap sol. You need to consider whether you want a nickel brushed look or chrome. Push this lever while gently pulling the top of the dispenser toward you. Remove the empty soap bag.

The top should swing away from the wall and hang down. Look inside the dispenser. You will see a small lever or bar near the wall on the bottom of the dispenser. Leave it for 5 minutes.

Wipe off the dispenser tube with a paper towel then immerse the entire assembly including the pump and the tubes in warm water. Look underneath the soap dispenser behind the push bar and soap nozzle.