To access and remove rollers on sliding panel unscrew stiles side components of aluminum frame.
How to replace rollers on sliding glass patio doors.
Do this at top and bottom until stile comes off should be left with glass edge in rubber boot.
Look for the two screws on the bottom ends of the sliding door.
Join us to learn the how tos of this home improvement.
The right way to replace sliding glass door rollers depends on whether you have a vinyl or aluminum door.
The lower screw is the adjustment screw.
Then if you have a vinyl door unscrew the old rollers and slot in the new ones before screwing them into place.
Make sure the rollers spin sufficiently before re installing your sliding glass door.
One screw sits above the other.
How to replace older sliding door rollers.
The rollers are located on the bottom of the sliding door and give the door the ability to slide.
Insert the new rollers in the door lining up the holes on the rollers with the holes in the bottom of the door insert the new rollers in place.
Replace the roller screws and use your phillips screwdriver to turn them clockwise until tight.
Grasp both sides of the sliding door and lift the door up into the top track.
Once unscrewed at top and bottom gently knock a block of wood against the frame with a hammer as shown in the picture below.
If you have an older sliding glass door your rollers may have become rusty because sliding door units did not always use stainless steel rollers.
Tilt the bottom of the door.