How To Set A Remote Garage Door Opener

Linking a new garage door opener 1.

How to set a remote garage door opener.

Most newer garage door openers function by learning the frequency of the handheld openers. Follow the cars instructions to program the remote control. Test the new garage door remote by pressing once to see if the door moves. Hold down a button on.

Pry off the bulb cover that covers up the unit s. Press the learn button until the led light comes on. Program your garage door remote co. Then go back to the car and press and hold the button you taght the remote to.

If the lightbulb on the opener flashes once it has been programmed. Press the remote control button programmed in step 2 until the garage door opener lights flash or just hold 4. Place the battery cover back on the remote control and press the white button on the remote control. To program a new remote into the system hold the learn button until the indicator light blinks on the opener.

To reset the system you will need to locate the button on the motor that reads learn or home in many cases this button will be located on the same side as the device s antenna and next to an led. If the genie door opener does not operate one or more of the dip switches is not set correctly. The remote control on your garage door needs to be programmed properly to allow it to communicate with the main base unit. Pull off the bulb cover to expose the motor unit s control panel.

To exit programming press and release any remote control button except the button that was just programmed. The learn button should be in the top right corner of the. Slide each individual switch on the remote control to the exact position each switch is on the door opener with your finger. Once the remote control has been taught to the car you go to the garage door opener and press and release the learn button.

While the indicator light is blinking press the button on your remote.