The handle is held in place by two 10mm bolts.
How to take a lever door handle off.
Turn the key 90 degrees so that it s oriented.
Pry off the cover plate if it has a notch.
It may be hidden.
Use a screwdriver to remove the set screws which will release the lock and lever from the.
Use a screwdriver to remove the set screws which will release the lock and lever from the opening.
Almost all lever handles are fastened to the door using screws though these screws may be hidden behind trim plates or other parts of the lock.
You can usually twist or pry it off with a flathead screwdriver to expose the screws.
If you see one insert a flat head screwdriver into the notch then gently pry off the plate.
Step 5 pull the lever off the stem by pulling it towards you.
Diy remove replace door s handle with hidden screws.
The cover plate behind the door knob or lever may be round or rectangular depending on the handle s design.
Expose hidden set screws.
Check around the plate where it meets the door for a small notch or cut out.
Using a philips head screwdriver turn counterclockwise to unscrew a knob with standard hex head screws.
A paperclip or small pin.
Look for pin holes in the rose or in the lever body itself.
How to remove a lever door handle without screws.
Insert the key in the handle on the outside of the door.
The other is a little harder to get at.
Pull the handle off.
A set screw is typically installed along the base of the lock on the interior side of the door.
Insert a hex wrench into the hole on the lever and turn counterclockwise until you feel the lever come loose.
One is easily accessable located right beside the handle with the door open.
Step 1 unscrew the door lever handle in order to get at the screws that hold the handle to the door you need to expose them by removing the plate that surrounds the lever handle also known as a rose.
How to remove schlage lock lever handles step 1.
The first thing you need to do is remove the inside door cover held in place by four screws and push in clips along the bottom that pull out easily.
Use a philips head screwdriver to unscrew them.