How To Tighten A Wall Mounted Bathroom Sink

First make a line on the wall with a pencil underneath the bracket and remove the bracket from the wall.

How to tighten a wall mounted bathroom sink.

Install the lag bolts through the wall bracket and hammer them into the pilot holes as far as they can go. If the sink p trap is in the way remove it by unscrewing the nuts holding it to the sink tailpiece and wall drain using. Step 5 attach the sink. A wall mount sink hangs from a bracket which is supplied with it and the bracket has to be mounted to the wall framing not to the wallboard.

Follow manufacturer s directions for the size and depth of. Lift the sink slightly while tightening the nuts with a wrench. If the sink is wide enough the bracket might overlap at least two of the wall studs and if so you may be able to anchor it to the studs with lag screws. Insert the mounting bolts.

Tighten the locknut you may have to hold the housing so it doesn t turn with the drain and remove any extra plumber s putty from around the housing. First if there is any caulking around sink holding sink and sealing it at the wall should be removed scraped off with some type of sharp. Attach the sink 1. Attach the faucets and other sink hardware to the wall mount bathroom sink before attaching the sink to the wall mount bracket.

With your cut out complete cut a 2 6 wood board to the length of stud 1 to. Mount the sink to the wall. Remove the 2 x 10 from the wall and drill 1 2 inch holes through the layout marks. Drill pilot holes into the wall at the marked locations.

Fasten the 2 x 10 brace to the wall studs by using 2 1 2 inch screws. Use the template that comes with the sink to mark the. Removing and rebuilding a wall hung bathroom sink. Use plumber s putty as you attach the.

Push your sink stopper into place through the housing. Install the threaded inserts to hold the bolts in place. Clear off the shelves under the sink to give yourself more room to work. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines.

Put your pivot rod into the opening on the drain piece and thread the rod through the end of the sink stopper. Now cut a piece out of the wall that is a few inches taller than the width of a 2 6 piece of wood real wood.