There should now be about 2 or 3 inches of vinyl overhanging the panel.
How to transfer door panel insert pattern new vinyl.
1 lay the vinyl flat on the table face down.
Use the contact on both the panel and the back side of the extra vinyl let it sit and fold the edges over tight.
Wiggle it gently from side to side as you grab the bottom section and push gently up.
2 lay your door panel foam side down on the back of the vinyl.
Slide the panel upward from the bottom.
Take special care to not get adhesive on your nice new vinyl surface.
Only takes a few minutes and changes the appearance of your car by a lot.
3 loosely trace around the panel leaving a 2 3 inch gap around the entire panel.
Once the bottom area of the panel has been freed pull it away from the door enough to allow fingers to be inserted in the gap along the bottom edge for leverage.
This step can be frustrating and time consuming.