Installing A Ceiling Light Controlled By 2 Wall Switches

I put in a two gang box for two switches.

Installing a ceiling light controlled by 2 wall switches.

Remove the light bulbs from the light sockets. This means that you will have black red white and bare. This means that switching the light on and off and dimming if available is all done via the remote control and not by a switch on the wall. Wiring two switches for two lights.

Attach each hot wire from the fan to a hot wire in the ceiling. Wiring for two light switches. Connect the red wire leading to the second switch to the top brass screw on the right side. A remote controlled ceiling fan bypasses one of the wall switches and allows for remote access to the ceiling fan s workings.

There is a remote inside the inner working of the fan which responds to a remote control. I am adding an outside light to my 1941 house. How do i take those two wires and feed two switches to have separate control for two switches. Connect the 2 ground wires with a fourth wire nut.

The ceiling fan with two switches will have two sets of wires. It s not the same as replacing any other outlet. A remote can speed up or slow down the fan turn the fan on and off or turn the lights connected to the ceiling fan on and off. Connect it to the screw on the left side of the switch.

One source is spliced to each switch with a pigtail to power the two lights. In some houses light switches on the wall might control individual outlets where you can plug in lamps and other lights. Mark this wire black. Take the white wire leading to the second box and mark its end black too.

The source is at the switch box and a 2 wire cable is run to each light. They re really convenient but if you ever need to replace that outlet there are some important things you ll need to keep in mind. Here two switches are wired in the same box to control two separate lights. To wire the ceiling fixture to the new wall switch first connect the copper grounding wire to the fixture.

Then splice the fixture s black lead into the new black wire. The hot wires are either black or red the white wires are neutral and the bare one is the ground wire. I have two wires leading to the gang box one white and one black. Screw the fan in place.