Position the pocket door pull on the edge of the door backwards and mark the center using a carpenter s pencil.
Installing door pull handle.
Mark the location for the door pull.
If you want to use a rose with a door pull be sure to account for the extra space to accommodate the diameter of the rose.
Trace the lever outline on the door s edge.
Insert the fastening screw s through the backside of the hole.
Mark the spots for the mounting screws using an awl.
Otherwise you may need to install an anchor so the handle isn t accidentally ripped off after a few uses.
Step 4 drill holes.
This assumes you have a solid core pocket door.
Installation of a flush pull handle onto a sliding barn door by carving a mortise with a chisel and mallet.
The process is easy and straightforward just make sure your door is made from solid wood.
Avoid over tightening the screw as this can crack or damage your cabinet door.
When considering a door pull with rosettes.
Thread the knob or handle onto the screw s.
If you have any questions regarding your installa.
Put the lever on the door in a sideways position to make cuts for the clearance.
While holding the knob or handle with one hand use a screwdriver to tighten the fastening screw.
A rose is a decorative hardware piece that is used to add a stylish touch where door handles mount to a door.
Once you ve chosen your pull or handle for your door it s easy to install your sliding door handles.
If you have a hollow core door then you will need to locate the wood block in the door and install the pull in that block.
Step 1 position the pull.
They are made in all sorts of sizes shapes and styles.
The normal height for hardware on an 8 foot door is 36 inches from the bottom side up.